To change the location of the split point
4.Now try playing something on the keyboard.
The Osplit point� is the point on the keyboard that separates
Y The lower range (left side) of the keyboard is assigned
the low range (split tone) from the high range (main tone).
the split tone, while the upper range (right side) is
assigned the main tone.
Y The location on the keyboard where the changeover1.While holding down the SPLIT button, press the
between the two tones occurs is called the split point.keyboard key where you want the highest note
See OTo change the location of the split point� on this
(the rightmost key) of the lower range (left side
page for details on changing the location of the split
range) to be.
point.
Y No sound is produced when the keys are pressed.
5.Press the SPLIT button again to unsplit the
keyboard and return it to normal.To adjust the volume of the split tone
Y This causes the indicator lamp above the button to go
out.1.Hold down the CONTROL button, and keep it
depressed until you reach step 4 of this
Z NOTE
procedure.
Y If you change or turn off a digital effect while split is turned on,
the setting you make is saved to the main toneOs settings only.
2.Press the ELEC PIANO 1 button.
Y This causes the indicator lamp above the button to
How digital effects are applied when split is
flash.
turned on
The following are the rules that determine what type of digital3.Use one of the procedures below to set the split
effects are applied to tones that are assigned to a split
tone volume to a value in the range of 40 to 127.
keyboard.
Y To scroll the volume setting value: While holding
down the CONTROL button, use the + (increase) and
Cause these digital effects to� (decrease) keys to scroll the volume setting value.
These conditions:be applied to both the mainHolding down either key changes the setting at high
tone and split tone:speed.
Pressing + and � at the same time automatically selects
Y Digital effects turned on
a volume setting value of 127.
for the main tone
Main tone digital effectsY To input the volume setting value: While holding
Y Digital effects turned on or
down the CONTROL button, use the number input
off for the split tone
keys to input a two-digit or three-digit volume setting
Y Digital effects turned offvalue in the range of 40 to 127. You can input a two
for the main tonedigit or a three-digit value. The level you input is
Y Layering turned on (pageapplied to the volume setting value when you release
Layered tone digital effects
E-13)the CONTROL button. The volume setting does not
change if you input a one-digit value or a value thatY Digital effects turned on
is outside of the allowable range.
for the layered tone
Y Digital effects turned off
for the main tone
Y Layering turned on (page
E-13), but digital effects
Split tone digital effects
turned off for the layered
tone
Y Layering turned offB2 C3
Y Digital effects turned on
for the split tone
+/�Number Input keys
keys
Y A note does not sound when you press a keyboard
key at this time.
4.Release the CONTROL button to complete the
procedure.
Z NOTE
Y The setting you make for the split tone volume remains in effect
even if you change to another tone.
428A-E-019AE-15
AP38_e_08-19.p651502.6.12, 15:55 |